No more loose breadboard contacts. This board is soldered — and it stays soldered.
UG56 ProtoBoard is a 10×10 cm prototyping board designed for real projects.
It works with:
- DIP components
- SMD components (0805, 0603, SOP)
- Power circuits (reinforced rails)
- Mixed analog/digital systems
- Reinforced power rails on both sides — handles current without voltage drop
- Two center rails — for I2C, UART, USB, or any signal bus
- Split analog/digital zones — with ground between them to reduce noise
- Ground guard ring around the perimeter — can be cut if not needed
- 2 mm plated mounting holes — for screws or grounding
- 10×10 cm size — fits cheap PCB tariffs
- White guide lines between pads — show the strip connections visually
- Square, rounded pads (2.54 mm grid) — fit 0805, 0603, SOP, and DIP
- Black with gold or blue with silver — because it should look good too
Breadboards lie. Contacts loosen. Noise creeps in. After a month — they stop working.
This board is soldered. Every connection is solid. It works for months, not minutes.
This board is ideal for:
- Power circuits
- Sensor interfaces
- Microcontroller prototypes (ESP32, ATtiny, STM32)
- Mixed analog/digital designs
- Permanent soldered setups
CC BY-NC-SA 4.0
Non-commercial use only. You may share, modify, and use it for personal projects. Commercial use requires explicit permission.
- OSHWLab: https://oshwlab.com/...
Designed and made by UniversalGeek